ONTAP MetroCluster FC Installation 9.8
NetApp® MetroCluster software is a unique high-availability and disaster-recovery solution. In this course you learn how to cable and set up a MetroCluster environment. Using active, participatory exercises, you practice the configuration and verification steps. You also learn how to identify component failures and practice recovery steps.
Koulutusmuoto
Remote
Kesto
2 päivää
Hinta
2040 €
- NetApp Employees
- Partner Professional Service Implementation Engineers
- Customers
This course focuses on enabling you to do the following:
- Describe the major architectural components of a MetroCluster environment
- Cable nodes, back-end FC switches, and FibreBridge devices
- Set up bridges and back-end FC switches
- Configure the clusters at both sites in a MetroCluster environment
- Set up a MetroCluster configuration and serve data to clients
- Detect and recover from failures in a MetroCluster environment
- Install and configure NetApp MetroCluster TieBreaker software
- Basic SAN knowledge
- Completion of an ONTAP Professional Compliance Program or equivalent
Module 1: Overview of MetroCluster
Introduction to MetroCluster software
Supported configurations
Implementation steps
Configuration tools and documentation
Module 2: MetroCluster Cabling
Disk requirements
Cabling overview
Controller cabling
Switch cabling
Module 3: Bridge and Switch Configuration
ATTO FibreBridge configuration
Brocade FC switch configuration
IOD and OOD delivery
Module 4: Cluster Configuration
Disk assignment
Cluster setup
Module 5: MetroCluster Configuration
Setup
Verification
Monitoring
SVM configuration
Module 6: Failure Scenarios
Switchover
Switchback
Failure scenarios
LIF placement
Module 7: TieBreaker Configuration
Introduction to TieBreaker
Installation
Configuration
